SI-Universal Encoder - Interface module - CONTROL TECHNIQUES
This SI-Universal Encoder interface module from Control Techniques is a programming console from the UNIDRIVE range.
Module compatible with M600, M700 drives
This SI-Universal Encoder Control techniques interface module is at your disposal to replace your defective equipment and has a guarantee adapted to your needs.
SI-Universal Encoder
The dual encoder port on the Unidrive M700 supports two position feedback interfaces, P1 and P2, via a high density 15-pin D-type connector. The SI-Universal encoder complements this functionality by allowing the use of additional input and output formats that would not normally be supported by the single 15-pin connector. It also provides closed-loop rotor flux control for induction motors (RFC-A) on the M600 model.
Features include:
Taking control of :
• SinCos with communication
• SinCos with or without switching
• Incremental quadrature with or without switching
• Impulse and direction
• SSI and EnDat
The module also provides an emulated encoder output that can be programmed to operate in the following modes:
• Quadrature Incremental
• Impulse and direction
• ISS
• The module also incorporates high-speed inputs for position capture.
Control Techniques is a leading manufacturer of AC and DC speed variation, servo motors and power conversion technologies for commercial and industrial applications. Their innovative products are used in the most demanding applications, requiring performance, reliability and energy efficiency.
Nidec Control Techniques has been at the forefront of industrial-driven drive technology for more than 40 years. They are dedicated to the advancement of automation. From product development to their headquarters to their 45 automation centers around the world, Nidec Control Techniques provides industry-relevant solutions. They guarantee high performance, reliability and energy efficiency in all applications.