A05B-2301-C305 - Teach Pendant - FANUC
This Fanuc branded reference box A05B-2301-C305 is at your disposal.
This Teach Pendant, for Robot FANUC working with controller R-J3, makes possible the programming and all the control operations and others of the robots FANUC.
This FANUC teach is reconditioned and tested on FANUC robot.
1) Power-down the controller, and disconnect the cable at the pendant
2) Remove the Velcro OEM hand strap from the upper cam only
3) Place the bumper face up on a clean, dry surface
4) Insert the hand strap through the lower-left corner (cut-out) of the bumper
5) Continue by inserting the pendant into the lower-left corner of the bumper. Ensure the
lower hand-strap cam and cable connections are fully seated into the bumper
6) Pull the bumper across the bottom of the OEM pendant, then along the sides and over the handle atop the pendant
7) Refit the Velcro OEM hand strap to the bumpered pendant
8) Note: If your local safety requirements dictate unencumbered or direct access to the
E-stop button, cut the protective rubber brow as your safety requirements dictate. A molded cut-line is embossed around the E-Stop brow. A utility knife may be used to cut the SantopreneTM
9) Reconnect the controller cable
10) Power-up the controller
11) Installation is complete
FANUC is a Japanese manufacturer of industrial robots, machining centers and numerical controls for machine tools
Since its creation in 1956, when the company’s founder, Dr. Seiuemon Inaba, introduced the concept of digital controls, FANUC has always been at the forefront of manufacturing techniques in the world. Moving from the automation of a single machine in the late 1950s to the automation of entire production lines over the following decades.